Williams County Airport frequencies
Williams County Airport (0G6) in Bryan, OH has no control tower, so nobody is sequencing traffic here — you announce your own position on 122.8. Every frequency below is in the order you tune it. · Open on the map
All of Williams County Airport — runways, frequencies, charts and live weatherTaxi & takeoff
- CTAF 122.8
- The common frequency pilots use to announce themselves to each other at a field with no operating control tower. Nobody is controlling traffic — you are self announcing. Report your position and intentions on entry and on each leg of the pattern, and listen well before you transmit.
- UNICOM 122.8
- A ground station run by the FBO rather than the FAA, for fuel, parking and airport services. Use it for services. Where the field has no separate CTAF, the same frequency doubles as the advisory frequency.
Departure & arrival Toledo
- App/Dep 134.35
- One radar controller working both arrivals and departures — normal at a smaller TRACON. The same frequency takes your climb out and your inbound call.
What to say on 122.8
Nobody is sequencing traffic at 0G6, so every call is you telling other aircraft where you are. Open and close with the field name so a pilot tuned to a shared frequency knows which airport you mean — 122.8 is not unique to Williams County Airport.
- Inbound, 10 miles out
Williams traffic, Skyhawk one two three four five, one zero miles south, inbound landing runway 07, Williams.
- Entering the pattern
Williams traffic, Skyhawk one two three four five, entering left downwind runway 07, Williams.
- Before taking the runway
Williams traffic, Skyhawk one two three four five, departing runway 07, Williams.
Pattern direction is not always left here — check the 0G6 traffic pattern before you announce a leg. The Chart Supplement is authoritative if 0G6 publishes a call name that differs from the airport's. Full guidance →
By procedure & sector (1 more)
| 307.0 | APCH/P DEP/P |
|---|
Every 0G6 frequency, as one table
| CTAF | 122.8 |
|---|---|
| UNICOM | 122.8 |
| App/Dep | 134.35 |
Frequently asked
What is the CTAF at 0G6?
Williams County Airport is non towered. The common traffic advisory frequency is 122.8 — announce your position and intentions on entry and on each leg of the pattern.
What is the approach frequency for 0G6?
App/Dep for Williams County Airport is 134.35, working as "Toledo". Call inbound for flight following or to begin an instrument approach.
More about 0G6
Frequencies from FAA NASR. For planning and education only; always verify against official sources.