Waynesville-St. Robert Regional Airport-Forney Field traffic pattern

Pattern altitude at Waynesville-St. Robert Regional Airport-Forney Field (TBN · KTBN) is 2,200 ft MSL (≈1,000 AGL) by the standard convention — none is published for this field, and 33 is charted right traffic.

All of Waynesville-St. Robert Regional Airport-Forney Field — runways, frequencies, charts and live weather

Pattern diagram

Drawn to scale from the FAA NASR runway alignments and the per end right traffic flags — pick a runway to see its pattern. Live wind picks the favored runway when KTBN reports it.

5,000 ftNMNxw 057°downwind 327°base 237°final 147°45° entry1533

RWY 15LEFT traffic

Heading
147° mag · 147° true
Dimensions
6,037 × 150 ft
TPA
2,200 ft MSL (≈1,000 AGL) · standard
Surface
Asphalt
Lights
4-light PAPI (left) (3°) + MALSR
ILS
ILS/DME · CAT I · LOC 110.9 (TBN) · GS 3.00°
Displaced thr
502 ft
CTAF
125.4
More details — RWY 15
Threshold elev
1,159 ft
Markings
precision
Approach obstacle
Pole, 9 ft, 210 ft from threshold, 450 ft L of centerline — 1:1 slope to clear · penetrates the 20:1 visual approach surface
Threshold crossing height
50 ft
TDZ elevation
1,158 ft
End lights
REIL

Condition: Good. Edge lights: High.

Pattern side + displaced threshold: FAA NASR · TPA standard 1,000 ft AGL (not charted) · layout: FAA runway-end coordinates

Pattern direction by runway

RunwayPatternHeadingPattern altitude
15 Left traffic 147° mag 2,200 ft MSL (≈1,000 AGL)
33 Right traffic 327° mag 2,200 ft MSL (≈1,000 AGL)

No pattern altitude is published for KTBN; the figure above is the AC 90-66B 1,000 ft AGL convention for propeller aircraft, rounded to the field. Turbine aircraft normally fly 1,500 ft AGL. Headings are the runway alignment; downwind is the reciprocal.

Flying the pattern at KTBN

Waynesville-St. Robert Regional Airport-Forney Field is towered, working 125.4. Contact the tower before entering the surface area and fly the pattern you are assigned — the directions below are the charted default when no instruction is given.

Watch the right traffic ends here: 33. A right pattern at a field where the other end is left is the single most common place to end up pointing at opposing traffic. The full entry procedure is here →

Frequently asked

What is the traffic pattern altitude at KTBN?

Waynesville-St. Robert Regional Airport-Forney Field has no traffic pattern altitude published in the FAA NASR data. The AC 90-66B convention for propeller aircraft is 1,000 ft AGL, which works out to roughly 2,200 ft MSL (≈1,000 AGL) here — but confirm it against the Chart Supplement before you fly, since a field can have a non standard pattern altitude that NASR does not carry.

Does KTBN have right traffic?

Yes, on one runway end: 33. Every other end at Waynesville-St. Robert Regional Airport-Forney Field is standard left traffic.

Do I fly a standard pattern at KTBN?

Waynesville-St. Robert Regional Airport-Forney Field is towered (125.4), so the pattern shown here is the charted default — but the controller's instruction overrides it. Expect straight in approaches, base entries and midfield crossings as traffic dictates.

More about KTBN

Pattern direction and alignment are drawn from the FAA NASR (28-day cycle); the diagram is generated, not an FAA chart. Pattern altitude is shown as published where NASR carries one, otherwise as the AC 90-66B 1,000 ft AGL convention. For planning and education only; always verify against the Chart Supplement.