Clarksville Red River City-J D Trissell Field traffic pattern
Pattern altitude at Clarksville Red River City-J D Trissell Field (LBR · KLBR) is 1,400 ft MSL (≈1,000 AGL) by the standard convention — none is published for this field, and every runway end is standard left traffic.
All of Clarksville Red River City-J D Trissell Field — runways, frequencies, charts and live weatherPattern diagram
Drawn to scale from the FAA NASR runway alignments and the per end right traffic flags — pick a runway to see its pattern. Live wind picks the favored runway when KLBR reports it.
RWY 17LEFT traffic
- Heading
- 172° mag · 174° true
- Dimensions
- 3,000 × 50 ft
- TPA
- 1,400 ft MSL (≈1,000 AGL) · standard
- Surface
- ASP
- CTAF
- 122.9
Enter the left downwind (heading 352°) on the 45° at 1,400 ft MSL (≈1,000 AGL).
Pattern side: FAA NASR · TPA standard 1,000 ft AGL (not charted) · layout: schematic (headings + lengths)
Pattern direction by runway
| Runway | Pattern | Heading | Pattern altitude |
|---|---|---|---|
| 17 | Left traffic | 172° mag | 1,400 ft MSL (≈1,000 AGL) |
| 35 | Left traffic | 352° mag | 1,400 ft MSL (≈1,000 AGL) |
No pattern altitude is published for KLBR; the figure above is the AC 90-66B 1,000 ft AGL convention for propeller aircraft, rounded to the field. Turbine aircraft normally fly 1,500 ft AGL. Headings are the runway alignment; downwind is the reciprocal.
Flying the pattern at KLBR
Clarksville Red River City-J D Trissell Field is non towered, so the pattern is self announced on CTAF 122.9. AC 90-66B asks for a report on entry and on each leg, and for the standard 45° entry to downwind at pattern altitude.
All ends are left traffic, which is the FAR 91.126 default — turns to the left unless the field charts otherwise. The full entry procedure is here →
Frequently asked
What is the traffic pattern altitude at KLBR?
Clarksville Red River City-J D Trissell Field has no traffic pattern altitude published in the FAA NASR data. The AC 90-66B convention for propeller aircraft is 1,000 ft AGL, which works out to roughly 1,400 ft MSL (≈1,000 AGL) here — but confirm it against the Chart Supplement before you fly, since a field can have a non standard pattern altitude that NASR does not carry.
Does KLBR have right traffic?
No. All 2 runway ends at Clarksville Red River City-J D Trissell Field use standard left traffic, so no right pattern is charted here.
What frequency is the pattern on at KLBR?
Clarksville Red River City-J D Trissell Field is non towered, so pattern position reports go on the CTAF, 122.9. AC 90-66B asks for self announcing on entry and on each leg.
More about KLBR
Pattern direction and alignment are drawn from the FAA NASR (28-day cycle); the diagram is generated, not an FAA chart. Pattern altitude is shown as published where NASR carries one, otherwise as the AC 90-66B 1,000 ft AGL convention. For planning and education only; always verify against the Chart Supplement.