Jim Sears frequencies
Jim Sears (3TA7) in Bridgeport, TX has no control tower, so nobody is sequencing traffic here — you announce your own position on 122.8. Every frequency below is in the order you tune it. · Open on the map
All of Jim Sears — runways, frequencies, charts and live weatherTaxi & takeoff
- UNICOM 122.8
- A ground station run by the FBO rather than the FAA, for fuel, parking and airport services. Use it for services. Where the field has no separate CTAF, the same frequency doubles as the advisory frequency.
What to say on 122.8
Nobody is sequencing traffic at 3TA7, so every call is you telling other aircraft where you are. Open and close with the field name so a pilot tuned to a shared frequency knows which airport you mean — 122.8 is not unique to Jim Sears.
- Inbound, 10 miles out
Jim Sears traffic, Skyhawk one two three four five, one zero miles south, inbound landing runway 17, Jim Sears.
- Entering the pattern
Jim Sears traffic, Skyhawk one two three four five, entering left downwind runway 17, Jim Sears.
- Before taking the runway
Jim Sears traffic, Skyhawk one two three four five, departing runway 17, Jim Sears.
Pattern direction is not always left here — check the 3TA7 traffic pattern before you announce a leg. The Chart Supplement is authoritative if 3TA7 publishes a call name that differs from the airport's. Full guidance →
Every 3TA7 frequency, as one table
| UNICOM | 122.8 |
|---|
Frequently asked
What is the CTAF at 3TA7?
Jim Sears is non towered. The common traffic advisory frequency is 122.8 — announce your position and intentions on entry and on each leg of the pattern.
More about 3TA7
Frequencies from FAA NASR. For planning and education only; always verify against official sources.
Something here wrong or out of date? Report a data problem.