Altus Air Force Base traffic pattern

Pattern altitude at Altus Air Force Base (LTS · KLTS) is 2,400 ft MSL (≈1,000 AGL) by the standard convention — none is published for this field, and 36L is charted right traffic.

All of Altus Air Force Base — runways, frequencies, charts and live weather

Pattern diagram

Drawn to scale from the FAA NASR runway alignments and the per end right traffic flags — pick a runway to see its pattern. Live wind picks the favored runway when KLTS reports it.

RWY 176LEFT traffic

Heading: 175° mag · 180° true
Dimensions: 3,500 × 90 ft
TPA: 2,400 ft MSL (≈1,000 AGL) · standard
Surface: Concrete

More details — RWY 176

Threshold elev: 1,379 ft
Markings: none
TDZ elevation: 1,379 ft

Condition: Good. Edge lights: High. PCN 121.

Pattern side: FAA NASR · TPA standard 1,000 ft AGL (not charted) · layout: FAA runway-end coordinates

Pattern direction by runway

Runway	Pattern	Heading	Pattern altitude
176	Left traffic	175° mag	2,400 ft MSL (≈1,000 AGL)
356	Left traffic	355° mag	2,400 ft MSL (≈1,000 AGL)
18L	Left traffic	175° mag	2,400 ft MSL (≈1,000 AGL)
36R	Left traffic	355° mag	2,400 ft MSL (≈1,000 AGL)
18R	Left traffic	175° mag	2,400 ft MSL (≈1,000 AGL)
36L	Right traffic	355° mag	2,400 ft MSL (≈1,000 AGL)

No pattern altitude is published for KLTS; the figure above is the AC 90-66B 1,000 ft AGL convention for propeller aircraft, rounded to the field. Turbine aircraft normally fly 1,500 ft AGL. Headings are the runway alignment; downwind is the reciprocal.

Flying the pattern at KLTS

Altus Air Force Base is towered, working 119.65. Contact the tower before entering the surface area and fly the pattern you are assigned — the directions below are the charted default when no instruction is given.

Watch the right traffic ends here: 36L. A right pattern at a field where the other end is left is the single most common place to end up pointing at opposing traffic. The full entry procedure is here →

Frequently asked

What is the traffic pattern altitude at KLTS?

Altus Air Force Base has no traffic pattern altitude published in the FAA NASR data. The AC 90-66B convention for propeller aircraft is 1,000 ft AGL, which works out to roughly 2,400 ft MSL (≈1,000 AGL) here — but confirm it against the Chart Supplement before you fly, since a field can have a non standard pattern altitude that NASR does not carry.

Does KLTS have right traffic?

Yes, on one runway end: 36L. Every other end at Altus Air Force Base is standard left traffic.

Do I fly a standard pattern at KLTS?

Altus Air Force Base is towered (119.65), so the pattern shown here is the charted default — but the controller's instruction overrides it. Expect straight in approaches, base entries and midfield crossings as traffic dictates.

More about KLTS

Pattern direction and alignment are drawn from the FAA NASR (28-day cycle); the diagram is generated, not an FAA chart. Pattern altitude is shown as published where NASR carries one, otherwise as the AC 90-66B 1,000 ft AGL convention. For planning and education only; always verify against the Chart Supplement.